Mitel 6800 Series, Administrator'S Manual, Page: 565 / 1113

Operational Features
5-302
Configuring the Action URI Connected Feature
Use the following procedure to configure the Action URI Connected feature on the phone.
For specific parameters you can set in the configuration files, see Appendix A, the section,
“Action URI Settings”
on
page A-167
.
1.
Click on
Advanced Settings->Action URI.
2.
In the “
Connected
” field, enter a valid URI for which the phone executes a GET on, when
it goes into the “connected” state. Leaving this field empty disables the Action URI Con-
nected feature. For example,
http://www.example.com/connect.php
3.
Click
Save Settings
to save your settings.
ACTION URI DISCONNECTED
The phones have a parameter, “
action uri disconnected
” that allow a disconnect event to
occur when the phone transitions from any active state (outgoing, incoming, connected, or
calling) to an idle state. This parameter can use the variable “
$$LINESTATE$$
”.
CONFIGURATION FILES
MITEL WEB UI
Note:
The
$$LINESTATE$$
variable is optional and not required when enabling the
“
action uri disconnected
” parameter.