11
mvip@mitech-ndt.com
Press arrow keys or F2 key to navigate up and
down to highlight the desired item.
Press
or F3 key to confirm the selection.
Press
key to cancel the change and close
current dialog box.
Make sure the selected or the automatically identified impacted device agrees with the connected one.
Incorrect type of the impact device will lead to erroneous result.
4.1.2 Impact direction setting
The instrument offers two methods for correction for non-vertical impact direction: automatic and manual.
With manual correction the user has to specify the actual impact direction. In automatic mode the
instrument will find out the impact direction itself and apply the appropriate correction.
Press arrow keys or F2 key to navigate to the
desired item.
Press
or F3 key to confirm the selection.
Press
key to cancel the change and close
current dialog box.
If AUTO item is selected, the impact direction will be detected according to the rebound signal of the
impact body and the measurement value will be corrected automatically by the main unit.
Note:
AUTO item is disabled for G type of the impact device.
The main unit detects the impact direction correctly only after base calibration.
If only vertical down measurements are performed, disabling AUTO mode is preferable.
4.1.3 Material setting
Press arrow keys or F2 key to navigate to the
desired material.
Press
or F3 key to confirm the selection.
Press
key to cancel the change and close
current dialog box.
Note:
Material selection will affect all measurements
in the current measurement series.
Hardness scale recovers to HL automatically
when material selection is changed. So please
select material before setting hardness scale.
When Hardness/Strength is set to hardness, the following materials are available: Steel and Cast Steel
、
Cold Work Tool Steel
、
Stainless Steel
、
Gray Cast Iron
、
Nodular Cast Iron
、
Cast Aluminum Alloys
、
Copper-Zinc Alloys
、
Copper-Aluminum Alloys
、
Wrought Copper and Wrought Steel.
When Hardness/Strength is set to strength, the following materials are available: Mild Steel
、
High-Carbon Steel
、
Cr Steel
、
Cr-V Steel
、
Cr-Ni Steel
、
Cr-Mo Steel
、
Cr-Ni-Mo Steel
、
Cr-Mn-Si Steel
、
Super Strength Steel and Stainless Steel.
