MiTAC Tyan S5542, Manual

Page: 29 / 112

http://www.tyan.com
29
J19: Fan Connector Reserved for Barebone
Signal Pin Pin Signal
TACH1 1 2 TACH6
TACH2 3 4 TACH7
TACH3 5 6 TACH8
TACH4 7 8 TACH9
TACH5 9 10 TACH10
GND 11 12 -
PWM2 13 14 PWM1
TACH11 15 16 SMBDATA
TACH12 17 18 SMBCLK
VCC3_AUX 19 20 PWM3
J26: Clear CMOS Jumper
Normal, RTC
reset (
Default
)
You can reset the CMOS settings by using this jumper. This can be
useful if you have forgotten your system/setup password, or need to
clear the system BIOS setting.
1. Power off system and disconnect power connectors from the
motherboard.
2. Remove the jumper from Pin_2 and Pin_3 (Default setting).
3. Move the jumper cap to close Pin_1 and Pin_2 for several seconds
to Clear CMOS.
4. Put jumper cap back to Pin_2 and Pin_3 (Default setting).
5. Reconnect power connectors to the motherboard and power on
system.
Clear RTC
registers
J111: SPI Bus Select Jumper
Pin 1-3 and 4-6 Closed: PCH to SPI (
Default)
Pin 2-4 and 3-5 Closed: BMC to SPI
J25: ME Firmware Update Jumper
Pin 1-2 Closed: Normal (
Default)
Pin 2-3 Closed: ME Recovery