MiTAC MUD-100, User Manual

Page: 22 / 25

14
3.2 Configuration Properties
The USB dongle “
Properties
” screen provides direct access to the hardware
configurations. To open the “
Properties
” screen, right-click on the Connection
Manager icon and click “
Properties
.”
The following table shows the properties that can be configured or viewed:
Property Description
Connection Status
Operating State
Allows you to select the operating state:
Disabled
,
Disconnected
, or
Connected
.
Signal Strength
(read only)
Shows the signal strength between 0 ~ 100 %.
Signal Quality
(read only)
Shows the signal quality between 0 ~ 100 %.
Transmit Rate
Select
Allows you to set the speed of transmission:
Auto
,
480
,
400
,
320
,
200
,
160
,
106.7
,
80
, or
53.3 Mbps
.
Tx Rate
(read only)
Shows the Tx rate 480 , 400 , 320 , 200 , 160 , 106.7 , 80 , or
53.3 Mbps
.
Rx Rate
(read only)
Shows the Rx rate 480 , 400 , 320 , 200 , 160 , 106.7 , 80 , or
53.3 Mbps .
Channel Select
Allows you to select the channel:
A
,
B
,
C
,
D
,
E
, or
Auto Detect
.
Current Channel
(read only)
Shows the current channel A , B , C , D , or E .
USB Dongle Status
Reset/Disconnect
Allows you to reset (
Reset
) the connection or disassociate
(
Disconnect
) the wireless hub from host (computer via the
USB dongle) and restart scanning.
Disable/Enable Allows you to turn on ( Enable ) or turn off ( Disable ) the USB
dongle to save PHY power.
Packets Sent /
Packets Received
(read only)
Shows the amount of packets sent from the USB dongle as
well as the packets received by the wireless hub.