Mirapoint RazorSafe 700, Hardware Manual, Page: 73 / 98

System-Board (Service-Only Procedure)
67
Figure 32 System-Board Removal
l
Installing the System-Board
To install the system-board:
1. Unpack the new system-board and remove the label placard that is inserted in
the memory module socket.
2.
Remove the labels from the placard and affix them to the information tag on
the front of the appliance (
Figure 1 on page 13).
3. Transfer the processors and heat sinks to the new system-board. See Removing
a Processor .
4.
Remove the memory modules and transfer them to the same locations on the
new board. See
Processors on page 57 and Installing Memory Modules on
page 56.
5. Install the new system-board:
a.
Angle the system-board as you lower it into the chassis and set the
system-board flat inside the chassis.
b. Maneuver the system-board so that all of the retention hooks on the chassis
are inserted into the retention slots on the system-board.
c.
Push the system-board toward the back of the chassis until the blue
retention pin locks into place.
6. If applicable, transfer the NIC hardware key.
7. Install the riser boards. See Installing Expansion-Card Riser 1 on page 51 and
Installing Expansion-Card Riser 2 on page 52.
8.
Reinstall the integrated storage controller card. See Installing the Integrated
Storage Controller Card on page 43.
9. If applicable, reconnect the RAID battery cable to the storage controller card.
1 system-board tray riser release pin 2 system-board
2
1