GUIDE TO INSTALLATION AND OPERATION
RCP-100 |
3
3 Installation
3.1 Unpacking
Make sure the following items have been shipped with your RCP-100. If any of the following items are
missing, contact your distributor or Miranda Technologies Inc.
- RCP-100
unit
- AC
power
cord
3.2 Rack Mount Installation
The RCP-100 is intended to be mounted in a standard 19" equipment rack. The unit is secured to the rack
using appropriate rack screws and washers (not provided).
For proper ventilation, make sure the rear and side panel air vents are not blocked.
3.3 Electrical
Installation
RS-232 (port A)
This connector is reserved for future expansion
RS-232 (port B)
Use this connector with an RS-232/RS-422 converter to connect the unit to imaging Symphonie, Solo,
Quartet and Quartet-2 series frames. Refer to figure 3.1 for connector pinout.
Figure 3.1
RS-232 connector Pinout (DE-9 male)
RS-422 Serial Connection (port B)
Use this connector to connect the unit to imaging Symphonie, Solo or Quartet and Quartet-2 series frames.
Refer to figure 3.2 for connector pinout.
Figure 3.2
RS-422 Connector Pinout (DE-9 female)
