48
Rev 1.0 • 25 May 10
5. Operation
Operating Concepts
3 Press the chop button.
4 Select another source. This is the second source. The chop is immediately activated on the rout-
ers (of the default destination) that support chop.
To terminate the chop, (1) press the chop button again to turn it off, then (2) select any source.
Case 2
—
Limited X-Y Mode
Follow these steps:
1 Select a destination. The ‘Destination’ field of the display shows the destination you chose.
2 Select a source. This is the first source.
3 Press the chop button.
4 Select another source. This is the second source. The chop is immediately activated on the rout-
ers (of the default destination) that support chop.
To terminate the chop, (1) press the chop button again to turn it off, (2) select the destination you
had chosen for the chop, then (3) select any source.
Case 3
—
Multi-Destination Mode
Follow these steps:
1 Select a source. This is the first source.
2 Press the chop button.
3 Select another source that
uses the same destination
as the first. This becomes the second
source for the chop. The chop is immediately activated on the routers (of the default destina-
tion) that support chop.
To terminate the chop, (1) press the chop button again to turn it off, then (3) select any source.
Summary of Contents for NV9606
