Miranda iMC-Panel-300, Operator'S Manual

Page: 121 / 176

109
iMC-Panel-300
Operator’s Guide (for Imagestore 750s)
Using the Keypad
Follow these steps to operate a keypad:
1 Press the desired ‘Keypad’ button (within a menu) to display the keypad menu for the
parameter you wish to change. A sample is shown here:
2 On the keypad, press the desired digits for your numeric value. The “entry register” shows
your entry in progress:
3 As necessary,
Press ‘Clear’ to clear the Entry register.
Press ‘Cancel’ to return to the previous menu, without having entered a number.
Press ‘Done’ to accept the new entry and return to the previous menu.
4 If an error message appears, (e.g., Invalid Entry), press ‘OK’ to start the entry procedure again.
The Entry register automatically clears.
Performing Transitions
The iMC-Panel-300 is a master control panel that sets up and initiates program transitions in an
Imagestore 750. The Imagestore 750 executes the transitions.
Setting up a transition is the primary task of the panel operator. Automation can also set up and
initiate transitions but that is of little concern to panel operators, except that operators may
inhibit or enable automation and must generally avoid interfering with automated transitions.
Most transition operations involve selecting a source on the preset bus, selecting a transition
type and rate, and transitioning the source to program. Some transitions involve applied video
effects and voice-overs.