background image

27

26

BATTERY SYSTEM

System Voltage

240VDC

Runtime: Full Load (minutes)

Runtime: Half Load (minutes)

14

11

5

3

SURGE PROTECTION AND FILTERING

Audible Noise at 1 m (3 ft.)

Noise Filter

Surge voltage let-through (as a
percentage of an applied ANSI
C62.41 Cat. B +/-4 kV)

Surge Response Time

Surge Current Capability

Surge Energy Rating

1050 J

1.2 

μ

s normal mode; <50 

μ

s common mode

<10%

normal and common mode EMI/RFI suppression

6500 Amps total

ENVIRONMENTAL

Operating Temperature (max)

Operating/Storage Humidity

Operating Elevation

0 to 40

°

C (+32 to +104

°

F)

0 ~ 95% Non-Condensing

0 to 2,000m (0 to +6,562 ft)

PHYSICAL

Weight - Net

Size - Net
L X W X H

Size - Shipping
L X W X H

Weight - Shipping

35.3 lbs
16.0 Kgs

46.5 lbs
21.1 Kgs

52.9 lbs
24.0 Kgs

65.0 lbs
29.5 Kgs

REGULATORY COMPLIANCE

Safety and Approvals

EMC Verification

cTUVus (Conforms to UL1778 4th Edition & CSA 22.2 no. 107.3-05)

FCC Class B, CE certified

Storage Elevation

0 to 15,000m (0 to +49,213 ft)

Storage Temperature

-15 to +50

°

C (+5 to +122

°

F)

192VDC

12

4

12

4

<60 dBA

26.0 x 17.3 x 3.5"
660 x 440 x 88.5 mm

39.4 x 23.6 x 8.7"
1000 x 600 x 222 mm

24.6 x 17.3 x 5.14"
625 x 440 x 130.6 mm

39.4 x 23.6 x 9.8"
1000 x 600 x 246 mm

Typical Recharge Time

8-hours to 90% after a full load discharge

Para Systems, Inc. (Para Systems) warrants this equipment, when properly applied and
operated within specified conditions, against faulty materials or workmanship for a pe-
riod of three years from the date of purchase.  For equipment sites within the United
States and Canada, this warranty covers depot repair or replacement of defective equip-
ment at the discretion of Para Systems.  Depot repair will be from the nearest authorized
service center.  The customer pays for shipping the product to Para Systems.  Para
Systems pays ground freight to ship the product back to the customer.  Replacement
parts and warranty labor will be borne by Para Systems.  For equipment located outside
of the United States and Canada, Para Systems only covers faulty parts.  Para Systems
products that are depot repaired or replaced pursuant to this warranty shall only be
warranted for the unexpired portion of the warranty applying to the original product.  This
warranty applies only to the original purchaser who must have properly registered the
product within 10 days of purchase.

The warranty shall be void if (a) the equipment is damaged by the customer, is improp-
erly used, is subjected to an adverse operating environment, or is operated outside the
limits of its electrical specifications; (b) the equipment is repaired or modified by anyone
other than Para Systems or Para Systems approved personnel; or (c) has been used in
a manner contrary to the product’s User's Manual or other written instructions.

Any technical advice furnished before or after delivery in regard to use or application of
Para Systems’ equipment is furnished without charge and on the basis that it represents
Para Systems’ best judgment under the circumstances, but it is used at the recipient’s
sole risk.

EXCEPT AS PROVIDED HEREIN, PARA SYSTEMS MAKES NO WARRANTIES, EX-
PRESSED OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND FIT-
NESS FOR A PARTICULAR PURPOSE.  Some states do not permit limitation of implied
warranties; therefore, the aforesaid limitation(s) may not apply to the purchaser.

EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL PARA SYSTEMS BE LIABLE
FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES
ARISING OUT OF THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE POSSI-
BILITY OF SUCH DAMAGE.  Specifically, Para Systems is not liable for any costs, such
as; labor for on-site installation, on-site maintenance or on-site service, lost profits or
revenue, loss of equipment, loss of use of equipment, loss of software, loss of data, cost
of substitutes, claims by third parties, or otherwise.  The sole and exclusive remedy for
breach of any warranty, expressed or implied, concerning Para Systems’ products and
the only obligation of Para Systems hereunder, shall be depot repair or replacement of
defective equipment, components, or parts; or, at Para Systems’ option, refund of the
purchase price or substitution with an equivalent replacement product.  This warranty
gives you specific legal rights and you may also have other rights which vary from state
to state.

No employee, salesman, or agent of Para Systems is authorized to add to or vary the
terms of this warranty.

Chapter 9: Limited Product Warranty

8 ms (Typical)

208VAC: 187 - 228VAC (240VAC: 216 - 264VAC)

Transfer Time

Output Voltage Range

ECONOMY MODE OPERATION

Low Voltage Transfer Point

At -10% of the rated input voltage transfers to the On-Line mode
8-Volt hysteresis to reset to the Economy mode

High Voltage Transfer Point

>96% (Full Load)

Efficiency (Economy Mode)

At +10% of the rated input voltage transfers to the On-Line mode
8-Volt hysteresis to reset to the Economy mode

Summary of Contents for 90001214

















Reviews: