minrray UV570, User Manual, Page: 22 / 58

FHD PTZ Camera

User Manual
16
How To Use
3.1
Remote Control
Remote control using instruction: There are wireless remote control and IR remote
control for options.
Steps for wireless remote control usage are as below:
1
）
Code Pairing
Press the "Settings" + "*" button for 3 seconds, the LED will turn off to flashing, after
releasing the button, the LED light will keep flashing to start the code pairing, the
receiver is powered on, and the LED will be off when the code pairing is successful; If
you use other remote control, you need to clear the code of this remote control, or re-
pair the code of the new remote control. If the code pairing has been unsuccessful,
the red LED light flashes for 20 seconds and then goes out, stop the code pairing
and go to sleep; at this time, press any key to wake up and re-pair the code.
Note: After the code is successfully matched, you need to select the camera address
to control it
2
）
Clear Code Data
Press the "Settings" key + "#" key from light off to flashing, the receiving end is
powered off and then powered on. The LED is off, indicating that the paired data is
cleared successfully
3
）
Enter Sleep Mode and Wake Up
If there is no operation in the working state, it will immediately enter the sleep mode,
and press any key to wake up.