minrray UV401, User Manual

Page: 25 / 37

- 24 -
4. Network Configuration
4.1 Network Connection
Network connection: Connect the product via network cable to external Internet access of the PC; or
alternatively, connect the product to Internet network via router or switch, in which case, the user is allowed to log
into product IP through a browser.
Note: Do not put electric wires and network cables in places accessible to people, since the resulting poor
contact of line may bring about unstable signal transmission that may impair video quality.
1. Method for Adding Network Segments
The computer must be loaded with the network segment where the product IP is located; the failure to add
network segment may cause login failure and other problems.
The default IP address of product is 192.168.5.163, and the computer shall be loaded with network segment 5.
Note: The IP addresses added shall be different from that of the computer or product; any IP to be
added must be verified for uniqueness.
The process is described below in detail:
First, open the "computer network local connection" property window, and select "
Internet protocol version
4 (TCP/IPv4)
"; double-click or click "
Internet protocol version 4 (TCP/IPv4)
" to get into the "Internet protocol
version 4 (TCP/IPv4)" property window; click on " Advanced " to enter advanced TCP/IP settings, and add IP and
subnet mask into the IP address bar ; click " OK " to finish the addition of IP network segment upon completion
of addition.
Users are allowed to add appropriate network segment based on their own modified product IP addresses.
To verify whether the network segment is added successfully, you can click "Start" in your computer, select
"Run", and enter cmd; click "OK" and open the DOS command window; enter "ping 192.168.5.26" and press the
Enter key, and the information shown in the figure will be displayed, which indicates the successful addition of
network segment.
Upon completion of power-on self-test of product, the above-noted procedure can also be followed to verify
whether the network is properly connected. For default IP, the network connection is considered normal if the
information shown in the figure below is displayed after the Enter key is pressed after the entry of "ping
192.168.5.163" into the DOS command window of computer.