!
!
2
3
CC-100 “CLOSET-CYCLIST” instruction manual
Please read this instuctions carefully before use.
Thank you for purchasing Minoura CC-100 “Closet-Cyclist” bike
display stand.
This stand can hang off up to two bikes vertically in a narrow space,
so you can place this stand even in a closet in your room.
This stand is designed for standard two wheel
bicycles. Do not use this stand for electric bikes
or tandems. The weight limit for two bikes is 50
kgs. or 110 lbs.
Make sure the stand is used on a level floor.
Failing to set-up and use this stand on a level
floor may cause the stand to fall over and cause
damage or injury.
This stand requires some assembly. You will need a M4 Hex wrench
and a 13 mm spanner in order to assemble Closet-Cyclist completely.
IMPORTANT NOTES
HOW TO ASSEMBLE YOUR CLOSET-CYCLIST
1
Screw the foot adjuster to the nut located on
each leg end.
Insert four M8x55 bolts into the holes on the
bottom of the Lower Pillar, then put through
the legs. The long leg is for rear section, and
the short legs are for front section. Be sure to
fit the legs to the shape of the horrow of the
bottom plate.
Lower Pillar
Rear Leg
Bottom Plate
Front Leg
(Fig. A)
(Fig. B)
(Fig.C)
Install the Reinforcement Arms between the Lower
Pillar and the Front Legs by tightening the M6x14
bolts for the pillar side, and M6x30 bolts for the
leg side. After installing the Reinforcement Arms,
tighten the M8x55 bolts firmly. Wrong
step may make you unable to install
the Reinforcement Arms.
Reinforcement Arm