GravityStand 2
instructions manual
1
Insert Plastic Bracket into
each Leg.
Plastic Bracket
Leg
2
Insert Metal Plate into
Lower Pillar, put Plastic
Cover onto each Leg, then
put through Guide Pin into
either hole for temporally
assembling.
Be sure the square holes on
Lower Pillar must face to
front side.
Lower Pillar
Guide Pin
Plastic Cover
Metal Plate
Leg
3
Screw M6x40 Bolt into the
hole without Guide Pin.
(You don't need to tighten
the bolts so much now.)
M6x40 Bolt
M6x40 Bolt
4
!
GravityStand is designed to keep
enough stability. But we highly
recommend you to fix the stand
to the wall with the supplied strap
M3.5x15 or 25
Screw
to prevent any
accident.
Cradle Hook is
padded with soft
urethane to protect
your bike finish.
Angle & position
are adjustable.
Cradle height is
adjustable in 3
positions without
requiring any tool.
Setting up is very
easy! Just lean to
the wall.
(Pillar should be set
parallel to the wall)
Remove Guide Pin.
Remove
5
Screw M6x40 Bolt to
another hole.
M6x40 Bolt
M6x40 Bolt
6
Tighten all M6x40 Bolts
firmly.
7
Install Metal Plate to the
top holes on Lower Pillar
with M6x12 Bolt.
Metal
Plate
M6x12 Bolt
- Page 1 -
