Bicycle Display Stand
971-3
instructions manual
(ver.2.4 2019/4)
!
Thank you for choosing Minoura 971-3.
Read this instructions carefully to understand well how this stand is constructed before starting assembling.
- 1 -
800mm
520mm
270mm
920mm
850mm
Completed image and dimensions of 971-3
(in the settings the bikes facing rightward)
IMPORTANT NOTES
• For standard 2-wheel bike only. No recumbent, tandem and any other type of bikes.
• For 24-inch wheel or larger only. Any bike with smaller wheel such as BMX or juvenile bike, and a special bike
with too low bottom bracket height or carbon monocoque frame may not fit to this stand.
• In the case of electric bike, the weight is limited under 30 kgs each.
• The bike is supported at just 3 points; front tire, rear tire and the bottom bracket. Adjust the BB Support height
precisely in each case to expect maximum stability.
• The bike direction is fixed as per the Stair Frame direction. Wrong direction cannot mount the bike properly.
• Do not step on this stand. The stand body is not so durable to support your weight.
• Setup this stand on horizontal and level floor, especially when installing the optional Caster Kit.
• When moving this stand, get off all bikes from the stand before action.
• Check regularly if each bolt and nut are firmly tightened.
Contact
MINOURA JAPAN
134-1 Shimomiya, Godo, Anpachi, Gifu 503-2312 Japan
Fax: +81-584-27-7505
Mail: [email protected]
Web: www.minoura.jp
Made in Japan
