there.
PREPARATION AND BASICS
Opening and closing the back cover IMPORTANT INSTRUCTIONS FOR PROPER
USE OF THIS CAMERA
The back cover of your Weathermatic-A is equipped with an O-ring that forms a
watertight seal when the cover is properly fitted to the camera body. This enables the
camera to be used under conditions (such as rain, snow, and in or underwater) where
use of conventional cameras is either not recommended or impossible.
IT IS OF UTMOST IMPORTANCE TO ALWAYS BE SURE YOUR WEATHER-
MATIC-A IS COMPLETELY CLEAN AND DRY BEFORE OPENING THE BACK
COVER. ALSO THAT THE BACK COVER'S O-RING IS CLEAN AND IN GOOD
CONDITION BEFORE THE BACK COVER IS CLOSED BY DOING THIS YOU
WILL OBTAIN THE FULL SERVICE LIFE INTENDED FOR THIS SEAL.
This manual created and owned by www.butkus.org/chinon and should only be located
there.
Ouverture et fermeture du dos du boitier
Opening the back cover
1. Hold the camera with the back cover facing you and lift the back-cover release tabs
on both back-cover release knobs. Then turn both back-cover release knobs
counterclockwise in the direction of the arrows until the back cover opens.
This manual created and owned by www.butkus.org/chinon and should only be located
there.
2. Lift the back cover away from the camera body. You can let the back cover hang
