Unpacking, setting up and pre-settings
2
Rev. 3.1.1/16.07.99
PagePro 25
2-19
Connecting the power cord
Use only the power cord delivered with the printer.
The laser printer requires a non-fluctuating power supply. Please refer to
your in-house technical specialist.
✔
Power supply: 220-240 V, ±10%
✔
Power supply frequency: 50-60 Hz, ±0.3%
1
Make certain that the printer's
power switch is in the 0 (off)
position.
2
Put one end of the power cord
(included with delivery) into the
power connection socket of the
printer.
3
Plug the other end of the power cord
into the socket.
CAUTION
Danger of short circuit if you use the wrong power cord!
Using a power cord with too low a capacity can result in a short circuit.
➜
Use only an extension cord with a higher capacity than the power
consumption of the printer.
➜
Never use a cable without a safety ground line.
➜
Make certain that you observe the standard requirements in your
country for connecting power cords to the power supply.
Summary of Contents for PagePro 25
