Minolta magicolor 2300 Series, Service Manual

Page: 125 / 144

125
2-4. Misfeed detection timing and remedies
(1) Paper misfeed in the paper feed-in section of the manual feed tray (Tray1)
<Detection timing>
<Remedy>
Category Details
Paper misfeed detected in the
paper feed-in section of the
manual feed tray If the end of the paper does not interrupt the synchronizing roller
sensor (PC2) when a set amount of time has passed after the
manual feed paper take-up sensor (SL1) is activated
Paper size error detected in the
manual feed tray
If PC2 does not pass through when a set amount of time has
passed after the paper interrupts the synchronizing roller sensor
(PC2)
Electrical components for detection of the paper misfeed
Synchronizing roller sensor (PC2)
Manual feed paper take-up solenoid (SL1)
Master board (PWB-A)
Step Remedy
Reference
page
WARNING DIAGRAM
Control signal
Location(electrical com-
ponent)
1
Perform initial check proce-
dures.
T-4 - -
2 Check PC2 operation. T-1 PC2_ON 5-D
2 Check SL1 operation. T-2 SL1_REM 8-G
3 Replace PWB-A - - -