3
3-14
Setting up the Pi5500 from a Windows Computer
Subnet Mask (Token Ring)
—If you need to set the subnet mask, enter one of the
following values:
•
255.0.0.0
if the IP address starts with a number less than 128
• 2
55.255.0.0
if the IP address starts with a number from 128 through 191
•
255.255.255.0
if the IP address starts with a number greater than 191
N
OTE
:
Be sure to confirm the subnet mask setting with your network administrator
before proceeding. In some cases, the required setting may be different from those
listed.
Gateway
If your TCP/IP network has a gateway, and users outside the gateway print to the
Pi5500 using TCP/IP, enter the gateway address. Obtain the correct gateway address
from your network administrator.
IP Auto
—Click to allow the Pi5500 to get the gateway address automatically for
printing with TCP/IP. This option is available only if you selected DHCP or BOOTP
as the protocol.
If you select a DHCP or BOOTP protocol and later change it to RARP, you must
return to Gateway Setup and set Get Gateway Address Automatically to No. You can
then set the address manually. RARP does not support automatic assignment of the
gateway address.
IP Static
—This option is available only if you answered No to Get Gateway Address
Automatically, or if you selected RARP as the protocol. Click to set the gateway
address for printing with TCP/IP. If your network uses a gateway, you must change the
default to a correct gateway address for your network.
