2
2-19
Network Setup options
IP Address
[127.0.0.1]
Enter the Pi5500 IP address for Token Ring. This IP address, unlike an IP address set
automatically, remains the same if you restart the Pi5500. You must change the default
to a valid address for your network.
Subnet Mask
[255.255.255.0]
This option lets you modify the subnet mask for printing with TCP/IP over Token
Ring. The subnet mask is set to
255.255.255.0
by default. To set the subnet mask,
enter one of the following values:
•
255.0.0.0
if the IP address starts with a number less than 128
•
255.255.0.0
if the IP address starts with a number from 128 through 191
•
255.255.255.0
if the IP address starts with a number greater than 191
N
OTE
:
Confirm the subnet mask setting with your network administrator before
proceeding. In some cases, the required setting may be different from those listed.
Gateway Address
[127.0.0.1]
This option appears only if you answered No to Get Gateway Address Automatically,
or if you selected RARP as the protocol.
Set the gateway address for printing with TCP/IP. After setting the gateway address,
proceed to set up Token Ring, if applicable, or choose Exit TCP/IP Setup and proceed
to Service Setup.
N
OTE
:
Simultaneous operation of the Pi5500 on both an Ethernet and a Token Ring
network is not supported.
IPX/SPX Setup options
To configure the Pi5500 for IPX/SPX protocols, choose IPX/SPX Setup from the
Protocol Setup menu.
