MINOLTA-QMS PagePro 9100, Installation Manual

Page: 43 / 80

Safety Information
35
English
International Notices
Power Cord
The following power cord requirements are in effect for your 220 V printer.
Voltage
Attention Norwegian users: This equipment is designed to operate within an
IT power system where the line-to-line voltage does not exceed 240 V.
Acoustic Noise
Machine Noise Regulation 3 GSGV, 18.01.1991: The sound pressure level at
the operator according to EN27779 is equal to or less than 70 dB (A).
Ozone Release (For All Users)
During printer operation, a small quantity of ozone is released. This amount is
not large enough to harm anyone adversely. However, be sure the room
where the printer is being used has adequate ventilation, especially if you
are printing a high volume of materials, or if the machine is being used
continuously over a long period.
Used Battery Precautions
Minimum
0.75 mm
2
Minimum H05 VV - F
The male plug is certified in the country in which the equipment is to be
installed, and the female plug is an IEC 320 connector.
All Areas CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended
by the manufacturer.
Dispose of used batteries according to the manufacturer’s
instructions.