Working with the printer
8
8-7
Loading media in the manual feed tray
1
Make sure that the tray cover is properly attached to Tray 1.
2
Open the media guides.
3
Insert the piece of media as far as
possible into the manual feed tray
(with the side to be printed facing
up).
?
How many pieces of media can
be fed at one time?
➜
Insert only one sheet of paper or
type of media at a time.
?
How are envelopes fed in?
➜
Place the envelope in the tray with the side to be printed facing up.
The flap of the envelope should be facing down and to the left.
?
How is letterhead fed in?
➜
Load letterhead with the side to be printed facing up and the pre-
printed letterhead at the top (facing the printer).
4
Adjust the media guides so that both sides of the media are secure.
Loading media in the lower feeder unit (Tray 2)
Note the following points:
✔
The optional lower feeder unit (Tray 2) is shipped with either a letter or
A4 tray. Legal and executive/B5 JIS trays are also available as option-
al accessories.
✔
Refill the tray only when it is completely empty.
✔
Paper must be loaded short edge first.
✔
Refer to the advice on loading media on page 8-1.
