MINOLTA-QMS MAGICOLOR 6110, User Manual

Page: 46 / 216

Loading Media 44
For information about media recommended for your printer, go to
www.minolta-qms.com/support, then click on Answer Base, or contact
Technical Support. See the Service & Support Guide for a complete listing of
support telephone numbers.
Loading Media
How do I prepare and load the media?
Preparing the Paper
1
Take off the top and
bottom sheets of a ream of
paper. Holding a stack of
approximately 250 sheets at a time, fan the stack to prevent static buildup
for the paper before inserting it in a tray.
5 "
Do not fan transparency media.
Don’t unwrap the paper above the printer, as this might cause paper
particles to fall into the printer.
Refilling the Media Tray
5 "
The illustrations show a universal media tray; however, instructions
are the same for a letter/A4 media tray.
Attention
Do not mix media of different sizes, types, or weights, as this will cause
printer jamming.
1
Remove the media tray from the printer.
When refilling media, first remove any media remaining in the tray.
Stack it with the new media, even the edges, then reload it. Although the
magicolor 6110 was designed for printing on a wide range of media types,
it is not intended to print exclusively on a single media type except plain
paper. Continuous printing on media other than plain paper (such as
envelopes, labels, thick stock, or transparencies) may adversely affect
print quality or reduce engine life.
O H P