MINOLTA-QMS magicolor 330, Service Manual

Page: 31 / 132

magicolor 330 Large-Capacity Input Feeder Service Manual LCIF-27
4.1 Error Message: Put < Size> Paper in OPT3 Bin
OPT3 bin tray is out of paper.
Logic control on the MCU PWB detected that the No Paper Sensor in OPT3 Bin is actuated. The Engine Diag-
nostic Menu may refer to the the OPT3 Bin no paper sensor as Tray 4 no paper sensor.
Step Actions and Question Yes No
SUSPECT COMPONENTS
The following components are associated with this specific
problem. One or more of these components may have failed
partially or completely. If you cannot isolate the problem using
this FIP, replace each component listed below, one at a time,
until the problem disappears.
• Wiring and connectors linking the LCIF with the MCU PWB
1
LCIF TRAY INSPECTION
Slide OPT3 tray out of the LCIF.
Is the Tray out of paper?
Load paper
into the Tray. Go to step 2
2
NO PAPER SENSOR TEST
1. Enter Diagnostics and test OPT3/Tray 4 No Paper Sensor.
2. Manually actuate and deactuate the No Paper Sensor.
Is "actuated" displayed when you manually actuate the
sensor? And, is "not actuated" displayed when you manu-
ally deactuate the sensor?
Go to step 3 Replac
OPT3/Tray 4
No Paper
Sensor
Assembly
(LCIF DRP
6.23)
3
Replace the Feeder PWB (LCIF DRP 6.10)
Does the error message still appear?
Go to step 4 Problem
Solved
4
Replace the MCU PWB (Base Engine DRP 6.123)
Does the error message still appear?
Go to sus-
pect compo-
nents Problem
Solved