Mini COOPER SE, Owner'S Manual

Page: 188 / 286

Overview
1 LED
2 Programmable keys
3 Hand-held transmitters of the system
Programming
General information
The battery of the hand-held transmitter
must be fully charged at the time of pro-
gramming to ensure an optimal range of the
integrated universal remote control.
1. Switch on the ignition.
2. Initial setup:
Press and hold the two outer buttons on
the interior mirror simultaneously for
approximately 10 seconds until the LED
flashes green rapidly. This erases all pro-
gramming of the buttons on the interior
mirror.
3. Press the interior mirror button to be
programmed. The LED on the interior
mirror will slowly begin flashing orange.
4. Hold the hand-held transmitter for the
system to be used approx. 1 to 12 in/2.5
to 30 cm away from the buttons on the
interior mirror. The required distance
depends on the hand-held transmitter.
5. Press and hold the button of the desired
function on the hand-held transmitter.
Canada: if programming with the hand-
held transmitter was interrupted, hold
down the interior mirror button and re-
peatedly press and release the hand-held
transmitter button for 2 seconds.
6. –
The LED lights up green: program-
ming completed.
Release the button.
– The LED flashes fast: programming
is not complete.
Press the button on the interior mir-
ror for 2 seconds and release. Per-
form this procedure three times to
complete the programming proce-
dure.
If the integrated universal remote
control remains nonoperational, con-
tinue with the special features for
change code wireless systems.
– LED does not flash green after
60 seconds: programming not com-
pleted.
Repeat steps 3 to 6.
To program other functions on other but-
tons, repeat steps 3 to 5.
Special feature of the rolling code
wireless system
If you are unable to operate the system af-
ter repeated programming, please check if
the system to be controlled features a roll-
ing code radio system.
Refer to the owner's manual for the system.
For systems with a rolling code radio sys-
tem, the integrated Universal Remote Con-
trol and the system also have to be
synchronized.
Please read the owner's manual to find out
how to synchronize the system.
Synchronizing is easier with the aid of a
second person.
Seite 188
CONTROLS Interior equipment
188
Online Edition for Part no. 01405A02680 - II/20