Mini Clubman 2019, Owner'S Manual

Page: 86 / 324

Closing via Comfort Access, refer to
page 77 .
Jam protection system
General information
If the closing force exceeds a specific value
as one of the front windows closes, the clos-
ing action is interrupted.
The window opens slightly.
Safety information
WARNING
Accessories on the windows such as an-
tennas can impact jam protection. There is
a risk of injury. Do not install accessories
in the area of movement of the windows.
Closing without the jam protection
system
In case of danger from the outside or if ice
might prevent normal closing, proceed as
follows:
1. Pull the switch past the resistance
point and hold it there.
The window closes with limited jam pro-
tection. If the closing force exceeds a
specific threshold, closing is inter-
rupted.
2. Pull the switch past the resistance
point again within approx. 4 seconds
and hold it there.
The window closes without jam protec-
tion.
On 5-door models: safety switch
General information
The safety switch in the driver's door can be
used to prevent children, for instance from
opening and closing the rear windows using
the switches in the rear.
If an accident of a certain severity occurs,
the safety function is switched off automati-
cally.
Switching on/off
Press button.
The LED lights up if the safety func-
tion is switched on.
Malfunction
General information
In certain situations a window can only be
operated to a limited extent.
– After a power failure during the opening
or closing process, the a window can
only be operated to a limited extent. The
system must be initialized in this case.
– The power window motors are equipped
with overheating protection. If a win-
dow is opened and closed several times
within a short period of time, the over-
heating protection switches the motor
off temporarily. Depending on the de-
gree of overheating, it may only be pos-
sible to close the window or it may not
be possible to operate it at all.
In this case: allow the power window
motor to cool down.
Initializing the system
The system can be initialized when the ve-
hicle is stationary and the engine is run-
ning.
Seite 86
CONTROLS Opening and closing
86
Online Edition for Part no. 01402723718 - VI/18