Minelab Manticore, Instruction Manual

Page: 45 / 78

CONTENTS
45
Target Tones
(Continued)
THE TARGET TONES EDITOR
The Target Tones Editor gives you full control of audio
properties for targets detected within each Tone Region�
The Target Tones Editor shares the same horizontal axis
as the ID Map, with Tone Regions corresponding to the
Target ID� The Tone Regions have adjustable Start and End
points, so you can change the width of each Region�
The volume of each Tone Region can be adjusted separately
to the global Volume setting�
Target ID 0–99
25
25
25
25
25
Tone Region
(e�g� T2)
Pi
tch 1–50
Volume Start/End
Points
ADJUST THE VOLUME OF TONE REGIONS
1.
Navigate to:
Settings
>
Target Tones
2. Press

/

to select the Target Tones setting you want
to adjust then press the Right Soft Key
( Edit)
�
3. Press

/

to navigate to the Region Volume that you
want to adjust�
25
25
4. Press the Right Soft Key ( Edit) � The Region Volume
will highlight in red�
25
25
5. Press  /  to adjust the Volume ( )�
6.
Press
( Back)
to return to the top‑level of the Editor�
ADJUST THE WIDTH/PITCH OF TONE
REGIONS
1. Navigate to: Settings > Target Tones
2. Press  /  to select the Target Tones setting you want
to adjust then press the Right Soft Key ( Edit) �
3. Press  /  to navigate to the Start/End Point you want
to adjust�
25
25
4. Press the Right Soft Key ( Edit) � The Start/End Point
will highlight in red�
50
5. Press

/

to move the Start Point ( )
or End Point ( )�
Press

/

to adjust the Pitch of the
Start/End Point ( )�
In 1/2/5‑Tone, only one Pitch can be assigned per
Tone Region� Therefore the Start and End Points move
together as the Pitch is adjusted�
16
In the 1/2/5‑Region All Tones settings, the Start and
End points can have a different pitch within a Tone
Region� Each point can move independently as the Pitch
is adjusted�
16
6. Press ( Back) to return to the top‑level of the Editor�