Minelab EQUINOX 700, Instruction Manual

Page: 33 / 61

33
CONTENTS
The Target Tone Setting controls the number
of different tones you will hear for different
types of targets, and the number of adjustable
Tone Regions for Advanced Settings�
Target Tone allows you to divide the Target ID range into
separate Tone Regions� Therefore, you can hear more or
less target information�
For The Target Tone setting has the options of 1, 2, 5, All
Tones (At) and Depth (dP)�
Gold* Mode has a Target Tone setting of 1 only, and
cannot be changed�
Target Tone adjustment is local; only the current Search
Mode Search Profile is affected by changes to this setting�
CHOOSING A TARGET TONE SETTING
1 Tone
Target responses give long and short beeps of the same
pitch, regardless of their Target ID�
2 and 5 Tones
Target responses give long and short beeps in 2 or 5
different pitches depending on their Target ID�
All Tones (At)
Target Responses give long and short beeps with a
different pitch for every Target ID�
Depth (dP)
Target Responses vary in pitch and volume proportional to
the target signal strength� All targets increase in volume
proportional to the target signal strength, therefore large or
shallow targets will sound louder than small or deep targets�
Conductive targets increase in pitch, and ferrous targets
have a constant low-pitch�
Shallow or large targets give a
stronger signal
Small or deep targets give a
weaker signal
Quiet,
ferrous
tone
Quiet,
low tone
Loud,
ferrous
tone
Loud, high
tone
Loud, very
high tone
Very quiet,
low tone
CHANGE THE NUMBER OF
TARGET TONES
1. Press the Settings button to navigate to Target Tone�
2. Use the Minus (–) and Plus (+) buttons to select the
new Target Tone setting�
The setting is indicated on the Target ID Number�
1 Tone 2 Tones 5 Tones All Tones (At) Depth (dP)
Target Tone Dependencies
When the Target Tone setting is changed, the options for
the following Advanced Settings also change:
ƒ
Tone Volume
ƒ
Tone Pitch
ƒ
Tone Break
For this reason, choose your Target Tone setting before
you begin adjusting the Tone Volume, Tone Pitch, and Tone
Break settings�
Target Tone
* EQUINOX 900 only