Minebea Intec Maxxis 5, Original Installation Manual

Page: 108 / 138

Module status (ST)
LED status Description Comments
Of Module is not initialized. - No power
- Module has the status "SETUP" or
"NW_INIT".
Constant green Module is initialized. Normal operation
Constant red Exception error - Module has the status "EXCEPTI-
ON"
- The exception error monitoring
system closes all open connec-
tions to the module.
4.6.9 DeviceNet interface
The DeviceNet interface card has the type designation PR 1721/54.
The ieldbus card contains all functionalities to make a complete DeviceNet slave with a
CAN controller and transmission speeds up to 500 kbit/s.
The DeviceNet connection is established by 5-pin terminal.
The card is inserted in the FB option slot, see Chapter
5.2.3 .
Technical data
Description Data
Internal connection
Pin strip, 50
‑
pin
External connection
5
‑
pin terminal (plug-in) in the module cover
Transfer rate 125, 250 and 500 kbit/s
Protocol DeviceNet Master Slave
- Polling procedure (polled IO)
- CRC error recognition according to IEC 62026 (EN 50325)
- Max. 64 station nodes
- Data width max. 512 byte "input & output"
Coniguration EDS ile
"sag_5900.eds"
MAC-ID (1…62)
Potential isolation Yes, optocoupler and DC/DC converter
Bus termination
120
Ω
at the cable ends
Bus load 33 mA @ U
DC
= 24 V
Cable type DeviceNet; color: petrol green; 2x2 twisted pair; screened
Cable impedance
150
Ω
Dimensions (LxWxH) 55x50x22 mm
Weight Approx. 33 g
Process Controller Maxxis 5 PR 5900 4 Device installation
EN-106 Minebea Intec