Note:
The standard RS-485 interface and the optional communications of RS-232C interface,
RS-422 interface and RS-485 interface are not interlocked each other.
17.4.2
Switch to RS-422/485 interface setting screen
Switch from the weighing screen to the RS-422/485 interface setting screen by the
following procedure.
17.4.3
Operation of RS-422/485 interface
Operation is ixed to [COMMAND MODE].
17.4.4 Setting item of RS-422/485 interface
1
Baud rate
Baud rate is selectable from [1 200 bps], [2 400 bps], [4 800 bps], [9 600 bps], [19
200 bps] or [38 400 bps].
[9 600 bps] is set as default.
2 Data bit length
The bit length of output data is selectable from [7 bit] or [8 bit].
[7 bit] is selected as default.
3
Parity
The setting of the parity bit is selectable from [None], [Odd number] or [Even num-
ber].
[Odd number] is selectable.
4 Stop bit
The setting of stop bit is selectable from [1 bit] or [2 bit].
[1 bit] is selectable.
5 Terminator
The terminator's setting is selectable from [CR] or [CR+LF].
[CR+LF] is set as default.
6 Decimal point addition
The addition of the decimal point is selectable from [None] or [Yes].
[None] is set as default.
7
Address
The address to make communication is set.
The address is input with ten keys in the range from 0 to 31.
[0] is set as default.
8 Switch of RS-422/485
The communication method is selectable from [RS-422] or [RS-485].
[RS-422] is set as default.
1. Select [MENU].
2. Tap [NEXT] in menu screen 1/2.
3. Select [OPTION] in menu screen 2/2.
4. Select [RS-422/485] in the optional setting screen.
17 Options
Weight Controller CSD-918
Minebea Intec
EN-153
Summary of Contents for CSD-918 Series
Page 239: ......
