— MIN.TARA
3.5 - Minimum load for auto. taring
— 1-DIGIT
3.5.1 - 1 display increment
— 2-DIGIT
3.5.2 - 2 display increments
— 5-DIGIT
3.5.3 - 5 display increments
— 10-DIG.
3.5.4 - 10 display increments*
— 20-DIG.
3.5.5 - 20 display increments
— 50-DIG.
3.5.6 - 50 display increments
— 100-DI.
3.5.7 - 100 display increments
— 200-DI.
3.5.8 - 200 display increments
— 500-DI.
3.5.9 - 500 display increments
— 1000-D
3.5.10 - 1,000 display increments
7 Operating
7.1
Weighing
This application is always available in operation.
Characteristics:
-
Zero with key
-
Adopt tare weight from the scale with key
-
Tare container weight automatically
-
Use key
to switch the display between:
-
Gross value and net value or normal and 10-times higher resolution
-
1st and 2nd weight value or display value and minimum initial weight SQmin
-
Print weight value:
-
GMP printout
-
Automatic printout
-
Automatic data output (see Chapter
)
7.1.1
Automatic tare
Menu: [ANWEND.]- [PARAM.1]- [AUT.TARA] (3.7) (see also Chapter
).
If menu item [EIN] (3.7.2) is active, the irst goods to be weighed that fall below the
speciied minimum load will be adopted into the tare memory on standstill.
The scale returns to the initial status if the scale is loaded with less than 50% of the
minimum load.
7.1.2
Minimum load for automatic tare and for automatic printout
Menu: [ANWEND.]- [PARAM.1]- [MIN.TARA] (3.5) (see also Chapter
For the minimum load, [MIN.TARA] (3.5) can be set:
* Factory setting
In this case "display increment" stands for the partial increment of the connected
weighing platform. If the partial increment is 1 g and 1000 display increments are
required, the minimum load is 1000 g (1000 increments) .
If the partial increment of the weighing platform is 5 g and the same number of display
increments as above are required, then the minimum load is 5000 g.
7 Operating
Combics 1 Series Complete Scales Models CAW1P, CAW1S, CAS1
Minebea Intec
EN-83