Mindray VS 8A, Operator'S Manual

Page: 57 / 278

3 - 23
mode, select the Main Menu quick key
→
from the Alarm column select Limits . Change
them if necessary.
3.11 Stopping a Parameter Measurement
To stop monitoring a parameter, follow this procedure:
1. Remove corresponding sensors from the patient.
2. Disconnect the sensor from the patient cable.
3. Disconnect the patient cable from the parameter connector.
4. If you are using the disposable sensor, discard it.
3.12 Turning Off the Monitor
Before turn off the monitor, perform the following check:
1. Ensure that the monitoring of the patient has been completed.
2. Disconnect the cables and sensors from the patient.
3. Make sure to save or clear the patient monitoring data as required.
To turn off the monitor, press and hold the power switch for 3 seconds.
Turning off the monitor does not disconnect the monitor from the AC mains. To
completely disconnect the power supply, unplug the power cord.
CAUTION
•
Press and hold the power switch for 10 seconds to forcibly shut down the
monitor if it could not be shut down normally. This may cause loss of patient
data.
NOTE
•
In case of a temporary power failure, if the power is restored within 30
minutes, monitoring will resume with all active settings unchanged; if the
monitor is without power for more than 30 minutes, the monitor behaves the
same as it is normally turned off.