Mindray VS 8A, Operator'S Manual

Page: 130 / 278

11 - 16
3. Select Parameters Setup
→
the NIBP tab.
4. Under Orthostatic BP Measurement , set Lying Duration .
11.10.4.2 Setting Standing BP Measurement Interval
Follow this procedure:
1. Select the Main Menu quick key
→
from the Configuration column select
Workflow
→
input the required password
→
select .
2. Select on the right of the workflow to be set. Make sure the workflow is
under Spot Check .
3. Select Parameters Setup
→
the NIBP tab.
4. Under Orthostatic BP Measurement , set Standing BP Measurement Interval .
11.10.4.3 Setting the Times of Standing BP Measurement
Follow this procedure:
1. Select the Main Menu quick key
→
from the Configuration column select
Workflow
→
input the required password
→
select .
2. Select on the right of the workflow to be set. Make sure the workflow is
under Spot Check .
3. Select Parameters Setup
→
the NIBP tab.
4. Under Orthostatic BP Measurement , set Maximum Standing BP Measure-
ments .
11.10.4.4 Setting Orthostatic BP Symptoms
Follow this procedure:
1. Select the Main Menu quick key
→
from the System column select Maintenance
→
input the required password
→
select
→
Module .
2. Under Orthostatic BP Symptoms , select to edit a symptom. You can also
select Add Symptom to create a new symptom and then select to edit it.
NOTE
•
You can set up to ten symptoms.
11.10.4.5 Setting Orthostatic BP Evaluation Criterion
You can set criteria for evaluation of the pressure differences. A negative/positive result
displays on the screen at the completion of the measurement.
Follow this procedure: