Mindray VS 8A, Operator'S Manual

Page: 128 / 278

11 - 14
3. Select Parameters Setup
→
the NIBP tab.
4. Under Average , enable Discard First Group of Readings .
11.10 Orthostatic BP Measurement
Orthostatic blood pressure is important for the assessment of fall risks. On the monitor,
you can measure the lying and standing blood pressure of a patient, and check the
differences for clinical evaluation. Orthostatic BP measurement is only applicable for
adult patient.
A license is required for the orthostatic BP measurement function. To check the license,
see
3.9.9 Checking Software Licenses .
11.10.1 Enabling Orthostatic BP Measurement
Orthostatic BP measurement is available only when the monitor is working in Spot
Check mode.
To enable Orthostatic BP measurement, follow this procedure:
1. Select the Main Menu quick key
→
from the Configuration column select
Workflow
→
input the required password
→
select .
2. Select on the right of the workflow to be set. Make sure the workflow is
under Spot Check .
3. Select Parameters Setup
→
the NIBP tab.
4. Under Orthostatic BP Measurement , enable Orthostatic BP Measurement .
11.10.2 Orthostatic BP Measurement Display
The following figure shows the orthostatic BP measurement screen.
1. NIBP unit
2. Lying blood pressure: displayed in the form of Sys/Dia (Mean)
3. Standing blood pressure: displayed in the form of Sys/Dia (Mean). The lowest val-
ues measured are used in contrasting.
4. Differences between the lying blood pressure and lowest standing blood pressure
1
3
2
5
8
4
7
6