Patient Data Management 10-17
On review screen, iStation screen, thumbnail area, send the image (s) to MedTouch/MedSight
devices.
Print Task: displays image or report printing tasks.
In the Task Management dialog box, the patient ID, name, destination, progress, type, contents and task
created time are displayed.
You can perform the following operations:
Click [Delete] to delete the task.
Click [Retry] to retry the failed task.
Click [Select All] to select all the tasks.
Task Status
When there are tasks underway, the task management icon displays as
. Click the icon to check
the process.
When tasks have failed, the task management icon displays as
. Click the icon to check the
reason for the failure.
When the task management icon displays as
, it means no task is underway or has failed.
DICOM Service Setting
On the Storage Task and DICOM Print Task page, click [Service Setting] to enter the DICOM service
setting screen. For details, see the DICOM/HL7 chapter.
Troubleshooting
If a serious error occurs, such as network disconnection or operation timeout, the system can try to
reconnect the network. The interval time and maximum retries can be set as desired. For details,
see the DICOM chapter.
10.9 Administration
10.9.1 Access Control
The system supports two types of users: system administrator and operator.
Administrator
The system administrator can access all function modules, and view all patient data, such as patient
information, images and reports, etc. Only one administrator is configured by default. The
administrator can add or delete operators.
Operator
The operator can only access the function modules with assigned privileges (for details about
privilege assignment, please refer to "10.9.4 Local Privilege Management" and "10.9.5 LDAP
Privilege Management"). The operator can only view exam information saved in the system and
operated by him or herself, such as patient information, images and reports, etc.
10.9.2 Enabling Access Control
The system administrator can preset the access controls, that is, whether an operator has the right to
access data in the system.
Access control only can be set by the system administrator.
Setting access control:
1.
Open the “Access Control” page using the path: [Setup]
[System]
[Access Control].
2. If
“Enable User Account Control” is selected, you must be authorized before accessing the data, and
you can configure password policy and LDAP, and change password. If unselected, you can access
all the data without authorization, and you cannot configure password policy and LDAP, and change
password.
