Mindray ePM 10M, Operator'S Manual

Page: 45 / 364

3 - 11
3.7.2 Privacy Mode
The privacy mode is a special clinical monitoring mode. In the privacy mode, the monitor does not display
patient information and monitoring data. This provides controlled access to patient data and ensures
confidentiality.
The privacy mode is only available when the patient admitted by the monitor is also monitored by the CMS. The
monitor continues monitoring the patient, but patient data is only visible at the CMS.
3.7.2.1 Entering the Privacy Mode
To enter the privacy mode, choose either of the following ways:
■ Select the
Privacy Mode
quick key
→
select
OK
.
■
Select the
Main Menu
quick key
→
from the
Display
column select
Privacy Mode
→
select
OK
.
The monitor has the following features after entering the privacy mode:
■
The screen turns blank.
■ Except for the low battery alarm, the monitor inactivate alarm tone and alarm light of all other alarms.
■
The monitor suppresses all system sounds, including heart beat tone, pulse tone, and prompt tone.
WARNING
.
•
In Privacy mode, all audible alarms are suppressed and the alarm light is deactivated at the monitor.
Alarms are presented only at the CMS. Pay attention to potential risk.
NOTE
•
The privacy mode is not available if the Department is set to OR.
•
You cannot enter the privacy mode if a low battery alarm occurs.
3.7.2.2 Exiting the Privacy Mode
The monitor automatically exit the privacy mode in any of the following situations:
■ The monitor disconnects from the CMS.
■ The low battery alarm occurs.
You can also operate the touchscreen to manually exit the privacy mode.
3.7.3 Night Mode
The night mode is a special clinical monitoring mode. To avoid disturbing the patient, you can use the night
mode.
3.7.3.1 Entering the Night Mode
To enter the night mode, follow this procedure:
1. Select the
Night Mode
quick key, or select the
Main Menu
quick key
→
from the
Display
column select
Night Mode
.
2. Change the night mode settings if necessary.
3. Select
Enter Night Mode
.
The night mode settings are as follows by default:
■
Brightness
:
1
■
Alarm Volume
:
2
■
QRS Volume
:
1
■
Key Volume
:
0
■
NIBP End Tone
:
Off