BeneVision N1 Patient Monitor Operator’s Manual
3 - 15
◆
Select the
Screen Setup
quick key
→
select the
Parameters On/Off
tab.
◆
Select the
Main Menu
quick key
→
from the
Parameters
column
select
Parameters On/Off
.
2.
Switch on or off desired parameters.
When a parameter is switched off, the monitor stops data acquisition and alarming for this measurement.
NOTE
•
When a parameter is manually switched off, you cannot monitor this parameter even if the related
accessories of this parameter are connected.
3.11.2
Displaying Parameter Numerics and Waveforms
You can configure the parameter numerics, waveforms, and their sequence displayed on the normal screen. To
do so, follow this procedure:
1.
Access
Tile Layout
in either of the following ways:
◆
Select the
Screen Setup
quick key
→
select the
Tile Layout
tab.
◆
Select
the
Main Menu
quick key
→
from the
Display
column select
Tile Layout
.
2.
Select a parameter numeric area or waveform area, and then from the popup list select an element you
want to display in this area. The parameters and waveforms you did not select will not displayed.
NOTE
•
ECG parameters and waveform are always displayed on the first line of the parameter numeric area
and waveform area.
3.11.3
Accessing Parameter Setup Menus
Each parameter has a setup menu in which you can adjust the alarm and parameter settings. You can enter a
parameter setup menu by using any of the following methods:
■
Select the parameter numeric area or waveform area.
■
Press the setup hard key
on the module front of the CO
2
module.
■
Select the
Parameter Setup
quick key
,
and then select the desired parameter
.
■
Select the
Main Menu
quick key
→
from the
Parameters
column
select
Setup
→
select the desired
parameter
.
NOTE
•
In this manual, we always use the first method to enter the setup menu. But you can use any method
you prefer.
3.11.4
Choosing a Screen
The monitor enters the normal screen after it is powered on. The normal screen is most frequently used for
patient monitoring. You can also select other screens. To do so, follow this procedure:
1.
Access
Choose screen
in either of the following ways:
◆
Select the
Screen Setup
quick key.
◆
Select
the
Main Menu
quick key
→
from the
Display
column select
Choose screen
.
2.
Select the desired screen.
3.11.5
Selecting the Big Numerics Screen
The big numerics screen displays parameter numerics in big font size. You can configure the parameters and
their layout on the big numeric screen. You can quickly switch the normal screen and the big numeric screen by
swiping left or right on the touchscreen with two fingers. You can also select the big numeric screen by
proceeding as follows:
