10 - 4
BeneVision N1 Patient Monitor Operator’s Manual
10.5
Changing Resp Settings
10.5.1
Setting the Resp Alarm Properties
To set the Resp alarm properties, follow this procedure:
1.
Select the Resp numeric area or waveform area to enter the
Resp
menu.
2.
Select the
Alarm
tab.
3.
Enter the password if required. For more information, refer to
6.9.3 Selecting Password for User
.
4.
Set alarm properties as desired.
10.5.2
Setting the RR Source
To set RR source, follow this procedure:
1.
Select the Resp numeric area or waveform area to enter the
Resp
menu.
2.
Select the
Setup
tab.
3.
Choose
RR Source
from the dropdown list.
When you select
Auto
, the system automatically selects the RR source according to the priority. The priority of
RR source is first CO
2
, and then RM, and finally ECG. When the current RR source does not have valid
measurement, the system automatically switches the
RR Source
to
Auto.
10.5.3
Choosing the Respiration Lead
To set the respiration lead, follow this procedure:
1.
Select the Resp numeric area or waveform area to enter the
Resp
menu.
2.
Select the
Setup
tab.
3.
Set
Resp Lead
.
If you cannot get optimal Resp waveform or you suspect the Resp value after choosing the Resp lead, you may
need to optimize the electrode placement.
10.5.4
Setting the Resp Waveform Size
To set the Resp waveform size, follow this procedure:
1.
Select the Resp numeric area or waveform area to enter the
Resp
menu.
2.
Select the
Setup
tab.
3.
Set
Gain
.
10.5.5
Setting the Resp Waveform Speed
To set the Resp waveform speed, follow this procedure:
1.
Select the Resp numeric area or waveform area to enter the
Resp
menu.
2.
Select the
Setup
tab.
3.
Set
Speed
.
