Mindray BeneHeart D2, Operator'S Manual

Page: 119 / 208

Defibrillator/Monitor Operator’s Manual 20 - 1
20
Network Connection
20.1 Network Introduction
The equipment supports the network function. The equipment can send real-time data to the CMS through
wired and wireless networks or send HL7 messages.
20.2 General Network Settings
20.2.1 Selecting a Network Type
1. Press the Main Menu button on the front panel, and select [ Others >> ]
→
[ Configuration >> ]
→
enter the
required password.
2. Select [ Network Setup ] and set [ Network Type ] to [ LAN ] or [ WLAN ].
3. Set [ Address Type ].
◆
[ DHCP ]: the equipment can automatically acquire network parameters.
◆
[ Manual ]: you need to manually input the IP address, subnet mask and gateway address.
4. Select [ Return ].
20.2.2 Storing Preset Sites
You can store up to 2 preset sites which can be selected in the drop-down list once successfully stored.
1. Press the Main Menu button on the front panel, and select [ Others >> ]
→
[ Configuration >> ]
→
enter the
required password.
2. Select [ Network Setup ].
3. Set [ Site Setup ].
◆
[ Select Site ]: select a site number in the drop-down list.
◆
[ Site Name ]: manually input the name of the target CMS.
◆
[ Site Address ]: manually input the IP address or domain name to specify the target CMS.
4. Select [ Return ].
20.2.3 Setting DNS
You can set DNS for connecting the CMS and server using domain name.
To set DNS:
1. Press the Main Menu button on the front panel, and select [ Others >> ]
→
[ Configuration >> ]
→
enter the
required password.
2. Select [ Network Setup ].
3. Set [ DNS Address Type ].
◆
[ Manual ]: the address of the DNS server must be manually entered.
◆
[ DHCP ]: the equipment will automatically acquire the address of the DNS server. This is only available
when [ Address Type ] is set to [ DHCP ] in the [ Network Setup ] menu.
4. If [ Manual ] was selected in Step 3, set [ Preferred DNS Server ] and [ Alternate DNS Server ].