Front Panel
Controls and Indicators
2 - 4
Accutorr V Operating Instructions
2. Systolic pressure (SYS)
The value of systolic pressure is obtained by the NIBP module. When no other LEDs illuminate
and the SYS LED displays three (3) flashing dashes and the LCD display (17) is blank, the
Accutorr V is in the standby state.
3. Mean pressure (MAP)
The value of mean pressure is obtained by the NIBP module.
4. Diastolic pressure (DIA)
The value of diastolic pressure is obtained by the NIBP module.
5. Pulse Rate (PR) Source indicator
The PR source is either SpO
2
or NIBP.
6. Pulse rate (PR)
The value of the pulse rate is obtained by the NIBP module or SpO
2
module. The PR unit is
beats per minute (bpm).
7. Oxygen saturation (SpO
2
)
The monitor displays the SpO
2
value in
%.
8. Temperature (Temp)
The monitor displays the temperature value in degrees C or degrees F, selectable in the Temp
SETUP dialog. The currently applied unit is illuminated as shown in callout (32).
9. PATIENT INFO key
Press to switch to the PATIENT INFORMATION dialog and automatically create a patient ID.
10. SET ALARMS key
Press to switch between the SET ALARMS dialog and the Trend display.
11. DISPLAY key
Press to switch between the PLETH display and Trend display.
12. MENU key
Press to switch between the SYSTEM SETUP dialog and the Trend display.
13. ON/STANDBY key/indicator
Press to turn the monitor on or off or to enter/exit the standby state. In the operating state,
press and hold for less than 1second to switch the device to standby. To turn off the monitor,
press and hold for more than 2 seconds.
Inside this key there is a working status indicator:
• Illuminated:
Indicates the monitor is powered on.
• Dark:
Indicates the monitor is powered off.
14. AC power indicator
• Illuminated:
Indicates the AC power is connected.
