If you have any questions, please call MINCEY MARBLE CUSTOMER SERVICE at 1-800-533-1806.
Mincey Marble Mfg., Inc.
|
1940 New Harvest Road, Gainesville, GA 30507
|
800.533.1806
|
minceymarble.com
BRUNSWICK BYPASS DOOR ENCLOSURE SYSTEM INSTALLATION (cont.)
5
Next, you are going to measure and trim the HEADER. Measure from Wall to Wall right above the Vertical Wall
Channels. Deduct
3
/
16
” from that measurement to allow for the END CAPS. Trim the Header from either end
using the Portable Band Saw or Hack Saw. It does not have to be centered.
,WLVUHFRPPHQGHGWKDWWZRSHRSOHDUHXVHGIRUWKHQH[WFRXSOHRIVWHSVEHFDXVHRIWKHGLFXOW\
of installing the Glass Doors without damaging them.
First, carefully place the Glass Doors into the
Shower - be sure to protect the Shower Pan and the Glass Doors, especially the bottoms.
MEASURE WALL TO
WALL, DEDUCT 3/16”
FOR END CAPS, TRIM
EITHER END OF
HEADER
Before installing the Shower Doors, you are going to
add LOCTITE BLUE 243 to the Adjustment Screws on the
ROLLERS. Unscrew the Screws on all of the ROLLERS
to where there is approximately a 1/4” recess. Apply a
small drop of LOCTITE BLUE 243 into the recessed area.
Adjust the screws on all four ROLLERS back up to where
there is approximately 1/4” of the screw protruding.
You are now ready to proceed.
HEADER
UNSCREW UNTIL
RECESSED 1/4”, ADD
LOCTITE, TIGHTEN BACK
TO 1/4” PROTRUDING
ON ALL FOUR ROLLERS
After applying LOCTITE to the ROLLER SCREWS, slide all
four ROLLERS into the HEADER as shown below, with the
SHOWER DOOR CONNECTING TABS positioned to the outside.
Slide the ROLLERS towards the inside of the HEADER and
install the END CAPS. Then, install the HEADER
onto the VERTICAL WALL CHANNELS by
SODFLQJLW¿UPO\LQWRSRVLWLRQ7KH
weight of the installed doors
will hold it securely into
position.
Once the Header is in place, slide the Rollers
towards outside edges to make room for the
Shower Doors. You will want to install the
2XWVLGH(GJH6KRZHU'RRU¿UVW<RXZLOOXVH
four 3/8” Pan Head Screws to connect the
Rollers to the Glass Door Brackets, using
LOCTITE BLUE 243 threadlocker when
installing. The two Rollers on each end
will allow for adjustment to align the heights
of the Shower Doors properly.
NOTE: LOCTITE BLUE 243 is required
as a threadlocker to secure the
installation of the Roller Screws.
LOCTITE is NOT provided with the doors,
but is readily available at many hardware
stores, online at mscdirect.com or through
Mincey Marble at 1-800-533-1806.
