Adjusting the volume by using another side of cleaning brush.
The volume will be higher when
you turn the switch clockwise.
And the volume will be lower
when you turn the switch
counterclockwise.
Green(Low)
Black(Off)
Red(High)
1. Turn the power on, and hold
the body of the hearing device.
3. Place the hearing device in your ear while you are grasping it.
2. Use your finger to grasp the
microphone and block the
hole.
Operating Diagram
Adjusting the Volume
Removing the Hearing Device from the Case
Open the lid of the case.
Pull upwards on the hearing
device until it is in the vertical
position.
Remove the hearing device
from the case.
Close the battery cap.
Accessories Listing
Install a 312(PR41) battery into
the hearing device as shown.
Positive terminal facing outwards,
close the battery cap.
Open the battery cap
To Insert the Hearing Device Battery
Usage
Close the case
,
the battery will
stay automatically isolation .
Place the Hearing Device
Insert hearing device into the
case.
Battery cap
Ear cap
Volume adjustment dial /
Microphone
Digital Hearing Device
Open
Volume adjustment dial
Close
Replacing the Ear Cap
1. Remove the old ear cap by pulling it back over the rim and
removing.
2. To replace the new ear cap turn it inside out so that the large
opening is exposed.
3. Place the ear cap onto the brim and roll it back into position
as illustrated. Then return the turnover brim to the original
state.
※
Keep the hearing device away from corroding gas or dust and
do not expose to direct sunlight, high temperatures or humidity.
※
If the ear cap is damaged or wax cannot be removed from it,
you will need to replace it.
Hearing Device Portable Case x 1 Cleaning Brush x 1
Ear Cap (S,M,L x 1) Trial Battery x 2
You will hear a ringing sound if you
put the hearing device into your ear
without holding the microphone.