MIMAKI Tx300P-1800B, Operation Manual, Page: 124 / 144

Chapter5 Troubleshooting
5-4
Warning / Error Messages
If some trouble occurs, the buzzer sounds and the display shows a corresponding error message.
Take an appropriate remedy for the displayed error.
Warning messages
Errors when performing operations
Message displayed in LOCAL
Message Cause Solution
Operation cannot be performed because
no media is detected.
• Execute after media is detected.
The motor is OFF after the cover was
opened etc. • Return to LOCAL and execute the operation
after completion of initialization.
An ink error occurred.
• Execute the operation after replacing with a
new ink pack.
The front cover or the maintenance
cover is opened. • Execute the operation after closing the
cover.
Data was received.
• Execute the operation after executing data
clear. ( P.2-29)
The emergency stop switch was
pressed. • Release the emergency stop switch to return
to normal function.
The origin of the belt wash unit cannot
be detected.
• Turn off the main power to the machine and
turn it on after a while.
If the same error message appears again,
contact your local distributor to call for ser-
vice.
Message Cause Solution
Multiple ink errors (unusable ink) have
occurred, making it impossible to feed
ink (printing and cleaning, etc.).
Replace with a new ink pack.
The waste ink tank count has exceeded
the prescribed amount.
Check the amount of waste ink in the waste
ink tank.
Conduct maintenance and waste ink tank
replacement, and reset the amount of waste
ink.
The used count of wiper has exceeded
the prescribed number. Execute maintenance, station maintenance
and wiper exchange and replace the wiper.
Print data is received in LOCAL.
Shift to REMOTE and execute printing.
Or, execute data clear and cancel printing.
Stable printing cannot be done because
temperature in the installed environment
(printer) is too high.
Adjust the ambient temperature to within the
specified scope (20°C to 35°C).
Stable printing cannot be done because
temperature in the installed environment
(printer) is too low.
INVAILD OPERATION
:MEDIA UNDETECT
INVAILD OPERATION
:MOTOR POWER OFF
INVAILD OPERATION
INK ERROR
INVAILD OPERATION
COVER OPEN
INVAILD OPERATION
DATA REMAIN
INVAILD OPERATION
EMERGENCY SWITCH
INVAILD OPERATION
WASH UNIT ORG.
Can't print/cartridge
Check waste ink
Replace WIPER
DATA REMAIN
MACHINE TEMP./H **°C
MACHINE TEMP./L **°C