MIMAKI Tx300P-1800B, Operation Manual, Page: 103 / 144

4-15
1
2
2
4
5
6
Chapter 4 Maintenance
Reset the set value
1
Press
(MENU)
in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press to select “NOZZLE
RECOVERY”, and press the key.
3
Press to select “RESET”, and
press the key.
4
Press and
(PAGE>)
(<<)
to selet the Nozzle line that
need reset, and press the key.
• A reset confirmation message will be displayed.
5
Press the key.
6
Press the key several times to
end the setting.
Check the condition for which nozzle
recovery cannot be performed
1
Press
(MENU)
in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press to select “NOZZLE
RECOVERY”, and press the key.
3
Press to select “CHECK”, and
press the key.
• Judgement Condition input screen will be
displayed.
4
Adapt each item of the judgment
conditions to your current state.
(1) Press [

][

] to select the setting item,
and press the [ENTER] key.
(2) Press [

][

] to select the setting value,
and press the [ENTER] key.
(3) Repeat steps (1) and (2), and set all of the
items.
5
Press .
• Begin to check if nozzle recovery at the set
printing conditions can be done.
• When the check is completed, the judgment result
is displayed on the screen.
6
Press several times to end
the setting.
• When using two types of ink with the hybrid function,
please select the type of ink to check.
Judgement Condition
Resolution 720 x 720
8 PASS
NORMAL Scan Speed
> MAPS 4
1 OVER PRINT
Judgement Condition
Select ink type
: Sb420
Judgement result
Judgement result
OK
If the nozzle
recovery
possible
HEAD1-AB 1
HEAD1-CD 0
HEAD2-AB 0
HEAD2-CD 2
NG
HEAD3-AB 1
HEAD3-CD 0
HEAD4-AB 0
HEAD4-CD 0
Judgement result
Judgement result
Judgement result
If the nozzle
recovery is not
possible
Head no. and
nozzle line The number of
nozzles that can
not be recovered.