MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 23 / 218

- 1.3 -
Moving The Device
This section explains to carry the device to e.g., an instruction location after assembled.
Raise the level feet before moving the device to a new location.
• When moving the device, take care not to apply excessive shock to it.
• Be sure to adjust the level feet to level the device at the new location.
• Connecting the power cable
Connecting the power cable cannot be installed by the customer.
Contact your local distributor to call for service to connect the power cable
as well as moving installation of the device.
We should take no responsibility for any troubles caused through the power
cable connection by the customer without calling for service.
Method of moving the device
When moving the device, it must be held up by at least six persons as illustrated at right.
• Move the Press roller to the evacuation position.
• Do not push the covers.
• Make sure no water in the cleaning fluid tank. In
case water in the tank, pump the water into other
container using attached hand pump.
Level feet
Raise the level feet before moving the device to a new location.
Lower and adjust the level feet to level the device at the new location.