MIMAKI Textile Jet Tx3-1600, Operation Manual, Page: 129 / 218

- 3.21 -
When the device will not be used for a long time [Storage Wash]
Procedure
1. Put the device into the MAINTENANCE mode.
2. Press the [ENTER] key.
3. Select [Station], and press the [ENTER] key.
4. Press the JOG key [ ] or [ ] to select [Storage
Wash].
5. Press the [ENTER] key to start the operation.
Nozzle cleaning starts.
The Y bar moves to the highest position and the table moves to the
back.
The wiper moves to the front, and the carriage moves to the
maintenance position.
6. Fill the cap with cleaning liquid using a drop-
per.
7. Press the [ENTER] key and set the exposure
time.
Set the time to expose the head to the cleaning liquid during
capping.
8. Press the JOG key [ ] or [ ] to set the expo-
sure time. (1 - 99 minutes)
9. Press the [ENTER] key to perform initialization.
Initialization is performed and the head is capped.
The progress of exposure is displayed.
10. Pressing the [END] key finishes the operation.
When the time set elapses, exposure finishes.
11. Perform the cleaning operation.
The progress of cleaning is displayed.
When cleaning finishes, ink drain washing starts.
The Y bar moves to the highest position and the wiper moves to the
front.
The carriage moves to the maintenance position.
Suction starts.
Suction for 10 seconds and a rest for 10 seconds continues succes-
sively.
FUNCTION
MAINTENANCE
< ENT >
MAINTENANCE
Station
< ent >
Station Maint
Sel
: CarriageOut
Station Maint
Sel
: Storage Wash
Wiper Cleaning
Completed
: ent
Fill Up Washings
Completed
: ent
Nozzle Cleaning
WaitTimer
: 1 min
Initialize
∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗ − − − − − − − −
Storage Wash
00:00:00
Wiper Cleaning
Completed
: ent
Cleaning
00:00:00