3-8
Chapter 3 Setup
4
Press the
key.
5
Press
to set drying
time, and press the
key.
• Set the drying time for scanning is completed. To
enable the drying time specified in your RIP,
select “Host”.
•
Scanning setting value
:
Host or 0.0 sec. to 9.9 sec.
•
Item selecting
: by the [
][
] keys
•
Time setting
: by the [
][
] keys
6
Press the
key several times
to end the setting.
Setting of Left and Right Margins
Set a non-printing area along the left and right edges of
the media.
The offset value against the standard margin 15mm is set
hereupon.
1
Press the
(MENU)
key
in
Local.
2
Press
to select SETUP 1 to 4, and
press the
key.
• Setup menu appears.
3
Press the
(>>)
.
4
Press
to select “Margin/L” or
“Margin/R” , and press the
key.
5
Press
to select a set value, and
press the
key.
•
Set value
: -10 to 85 mm
6
Press the
key several times to
end the setting.
Setting of Refresh
Sets the interval of refresh performed during printing.
1
Press the
(MENU)
key
in
Local.
2
Press
to select SETUP 1 to 4, and
press the
key.
• Setup menu appears.
3
Press the
(<<)
.
4
Press
to select “Refresh” , and
press the
key.
5
Press
to select a set value, and
press the
key.
•
Set value
: Host/Lv.0 to Lv.3.
6
Press the
key several times to
end the setting.
Setting of Vacuum Fan
Sets the absorbability of the media.
By setting the absorption power to match the media, you
can prevent print errors due to media rise-up.
1
Press the
(MENU)
key
in
Local.
2
Press
to select SETUP 1 to 4, and
press the
key.
• Setup menu appears.
3
Press the
(<<)
.
4
Press
to select “Vacuum Fan” ,
and press the
key.
5
Press
to select a set value, and
press the
key.
•
Set value
: Host/Weak /Standard/ Strong/ OFF
6
If you choose any other option than "OFF"
in step 4, press
, choose whether
to constantly operate the vacuum fan, and
press the
key
•
ON
:
Vacuum fan is constantly on.
•
OFF
: Vacuum fan is only on when printing or
performing jog operation.
7
Press the
key several times to
end the setting.
Setting of Print Speed
Changes the media feeding speed and scanning spped in
printing.
• The margin setting is enabled only if the media
detection method is set to “AUTO”.
• The margin setting is reflected when the media
width is detected.
• Pay attention to the settings of the right and left
margins when printing with the media press. If any
of the margins is set to a negative value, printing
may start from a position on the media press.
• When switch the setting 1 to 4 /Temporary or copy
the setting, there is a case that the setting screen
of vacuum fan is displayed.
