MIMAKI SWJ-320EA, Operation Manual

Page: 35 / 116

2-9
2
2
2
2
About entering media remaining
amount
When you set [Media remaining amount display] to “ON”
(
P.3-14), you are prompted to enter the media
remaining amount after completing the setting of the
Logical Seek.
1
When the setting of the Logical Seek is
completed, you are prompted to “Input
Media Length”.
• When you set “Media remaining amount display”
of the machine setting to “OFF”, this screen is not
displayed. (
P.3-14)
2
Press to enter the media
remaining amount.
3
Press the key.
Detecting media width when media
detection method is “MANUAL”
1
Press to select a media (roll or
leaf).
• The media detection screen appears.
2
Press to enter the number of
mounted media, and press the
key.
3
Select and press the key.
• The "RIGHT EDGE POSITION" screen will be
displayed.
4
Press to move the head, align
the LED pointer to the right edge of the
media and press the
key.
• The "LEFT EDGE POSITION" screen will be
displayed.
5
In the same way as in step 4, decide the
left edge position of the media and press
the
key.
• Media width is set.
• When the media detection is completed, the
screen of “Setting a roll media as described in
step 21 is displayed.
Follow the steps 22 and later.
Setting a narrow roll media
When you use narrow roll media (up to 1.6m), set the
media on the narrow roll holder.
1
Set the setting of the feeding unit to “OFF”
in “Setting Feeding unit” of the machine
setting. (
P.3-13)
2
Open the front cover and rear cover.
Media Detect
Logical Seek
50.0m
Quality
Input Media Length
• At the take-up side, set the printed surface to
“involuted”. (If you set it to “revoluted”, it may
adversely affect the media feeding.)
• When setting a media, place the media in the
center of the machine . If the media is set to the
right or left, the media may not be transported
normally.
Media Detect
Set number of
MANUAL
1
Print Area
Front cover
Rear cover