MIMAKI SWJ-320 S2, Maintenance Manual

Page: 69 / 210

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.8 P.1
R.1.1
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment > Adjustment Items > PRINT ADJUST
Model SWJ-320S Issued 2012.07.19 Revised 2013.02.15 F/W ver 1.0 Remark
1.1
Rev.
4.2.8 PRINT ADJUST
 Outline
Adjust the ink landing position.
 Work Procedures
1. Select [#ADJUST / PRINT ADJUST].
2. Select [720Std].
3. Select the correction item.
Perform all types, SiDir, ReDir, and BiDir.
4. Print.
5. Enter the correction values.
 SiDir/ReDir pattern
#ADJUST
PRINT ADJUST[ENT]
#PRINT ADJUST
:720Std
#PRINT ADJUST
SELECT :SiDir
#PRINT ADJUST
SiDir :PRINT
#PRINT ADJUST
** PRINTING **
720std
SiDir
WF1
H1A‑H1B : 0.0
:
540Std
:
720Hi
:
1080Std
:
BASIS SET 720std
:
ReDir
:
BiDir
‑99.9〜99.9
#PRINT ADJUST
H1A‑H1C
H1A‑H1D
H1A‑H2A
:
H1A‑H2D
Due to the differences in distance between platen
and heads, the adjustment position of the refer-
ence lines may vary depending on the location.
Be sure to verify all patterns and enter correction
values so that the variation is kept to a minimum.
H1A
H1B
H1C
H1D
H2A
H2B
H2C
H2D
H3A
H3B
H3C
H3D
H4A
H4B
H4C
H4D
H1A
Figure when viewed using a magnifying lens
Enter a correction value in the positive direction
H1A (Reference lines)
Reference lines
Adjustment lines
Enter a correction value in the negative direction
H1A (Reference lines)