9
Replacing the Spout Rubber Assy
Install the spout rubber in an eco case in order to reduce ink leakage from the 2L ink pack.
The spout rubber is a supplied part. (SPA-0250: Set of 8 Rubber stopper 2L for case)
The replacing timing sign of the spout rubber will be shown about once every half-year. Please replace the spout
rubber when you see the sign on the display.
1
Open the 2L eco case.
2
Remove the 2L ink pack.
3
Remove the spout rubber assy.
• Press against the top of the spout rubber assy and pull it out
vertically.
4
Attach the new spout rubber assy.
• Replace all eight spout rubber assys as a set at the same time.
• Depending on the usage environment and usage conditions, the spout rubber may deteriorate within half a year.
If the gap in the center expands as shown in the picture, please replace it regardless of if there is a warning message.
• Reset the counter according to the following procedures if replacing any time other than when the warning
is displayed.
(1) Press the
key in LOCAL to select “INFORMATION” and press the
key.
(2) Select “USAGE” and press the
key.
(3) Press the
key.
(4) When display
, press the
key and reset the counter.
When exchanging 2L ink pack, be sure to wear goggles and gloves. Ink may spatter and get in
your eyes accidentally.
It is available to use
It is necessary to replace
The beginning of spout rubber
EcoCase/SpoutRubber
RESET?
[ENT]
Spout rubber Assy
