Use the work holder
34
5
Tighten the screws (2 pieces) retaining
the right work holder.
6
Put the ball part of the right work holder
and the work together.
7
Place the left work holder close to the
work.
• Place the work and left work holder several centimeters away
from each other to adjust the left work holder later.
8
Align the height of the ball part of the left work holder with the flat
part of the side of the work.
• Loosen the thumbscrew of the supporting section of the ball, adjust the height, and then tighten the nut.
• When lining it up with the side that is uneven, it may affect drawing; try to line it up with the part that is as flat
as possible.
9
Slide the left work holder, and put the
ball part of the left work holder lightly to
the work.
• Make sure that the work holder and the ball
touch each other lightly; otherwise the work
may raise and affect drawing depending on
the mass of work.
Screw
How to loosen or tighten
Ball part to line up
with the work
